CLI Guide

ManualsBrandsDell ManualsAccess PlatformsOS9

641

642

643

644

645

646

647

648

649

650

Table Of Contents

● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the

stack/slot/port/subport information.

● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then

the stack/slot/port information.

● For a port channel interface, enter the keywords port-channel then a

number.

Command Modes EXEC

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

EMC Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on S-Series and Z–Series.

Usage

Information

IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results.

debug ip igmp snooping

Enable debugging of IGMP snooping packets on interfaces and groups.

Syntax

debug ip igmp snooping [group address | interface]

● To disable debugging of IGMP snooping, use the no debug ip igmp snooping [group

address | interface] command.

● To disable all debugging, use the undebug all command.

Parameters

snooping Enter the keyword snooping to enable debugging of IGMP snooping.

group-address

(OPTIONAL) Enter the IP multicast group address in dotted decimal format.

interface

Enter the following keywords and the interface information:

● For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the stack/slot/port/subport information.

● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE

then the stack/slot/port/subport information.

● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

stack/slot/port[/subport] information.