CLI Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the Z9500 and S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
fip-snooping port-mode fcoe-trusted
Configure the port for bridge-to-bridge links. It is not recommended to use this command because multi-hop FSB is not
supported.
Syntax
fip-snooping port-mode fcoe-trusted
To remove the bridge-to-bridge link configuration from the port, use the no fip-snooping port-
mode fcoe-trusted command.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) This command is deprecated.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: This command is deprecated from the Dell EMC Networking OS.
show fip-snooping config
Display the FIP snooping status and configured FC-MAP values.
Syntax
show fip-snooping config
Command Modes
● EXEC
● EXEC Privilege
594 FIP Snooping