CLI Guide

Content Addressable Memory (CAM)
You can use content addressable memory (CAM) commands to configure the amount of memory allocated to CAM memory
partitions.
NOTE: Not all CAM commands are supported on all platforms. Be sure to note the platform when looking for a command.
NOTE: If you are using these features for the first time, contact Dell EMC Networking Technical Assistance Center (TAC)
for guidance.
Topics:
• cam-acl (Configuration)
• cam-acl-egress
• cam-optimization
• cam-sharing
• cam-threshold
• feature ipv6acloptimized
• show cam-acl
• show cam-sharing
• show cam-usage
• test cam-usage
• Unified Forwarding Table Modes
cam-acl (Configuration)
Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and
Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet Connectivity
Fault Management (CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number [vman-qos | vman-
dual-qos number] [etsacl number ] [fcoe number][fedgovacl number]
[nlbclusteracl number] [ipv4pbr number] [openflow number] [vrfv4acl number]
[ipv4udfenable] [ipv4udfmirracl number]
Parameters
default Use the default CAM profile settings and set the CAM as follows:
● L2Acl : 2
● Ipv4Acl : 2
● Ipv6Acl : 0
● Ipv4Qos : 2
● L2Qos : 2
● L2PT : 0
● IpMacAcl : 1
● VmanQos : 0
● EtsAcl : 0
●
FcoeAcl : 0
● ipv4pbr : 0
● vrfv4Acl : 0
● Openflow : 0
● fedgovacl : 0
● nlbclusteracl: 0
9
Content Addressable Memory (CAM) 449