CLI Guide

Parameters
source address Enter the IPv6 address of the network or host from which the packets were sent in
the x:x:x:x::x format followed by the prefix length in the /x format. The range is /0
to /128. The :: notation specifies successive hexadecimal fields of zero.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all routes are subject to the filter.
host ipv6-
address
Enter the keyword host followed by the IPv6 address of the host in the x:x:x:x::x
format. The :: notation specifies successive hexadecimal fields of zero.
destination
address
Enter the IPv6 address of the network or host to which the packets are sent in
the x:x:x:x::x format followed by the prefix length in the /x format. The range is /0
to /128. The :: notation specifies successive hexadecimal fields of zero.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
Defaults Not configured.
Command Modes ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series TeraScale.
7.8.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series TeraScale Added the monitor option.
deny tcp
Configure a filter that drops TCP packets that match the filter criteria.
Syntax
deny tcp {source address mask | any | host ipv6-address} [operator port
[port]] {destination address | any | host ipv6-address} [bit] [operator
port [port]] [count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
● Use the no seq sequence-number command syntax if you know the filter’s sequence number
● Use the no deny tcp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} command
Parameters
source address Enter the IPv6 address of the network or host from which the packets were sent in
the x:x:x:x::x format followed by the prefix length in the /x format. The range is /0
to /128. The :: notation specifies successive hexadecimal fields of zero.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all routes are subject to the filter.
host ipv6-
address
Enter the keyword host followed by the IPv6 address of the host in the x:x:x:x::x
format. The :: notation specifies successive hexadecimal fields of zero.
operator (OPTIONAL) Enter one of the following logical operand:
226 Access Control Lists (ACL)