CLI Guide

Parameters
stack-unit
number
Enter a stack member identifier of the switch that you want to add to the stack.
module slot
number
Enter the slot number of the module to identify the slot to be provisioned.
module type Enter the module type from one of the following:
● QSFP+
● QSFP28
● QSFP28_4CXP
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the S6100–ON
Usage
Information
This command is used to provision the switch to accept a particular type of module.
NOTE:
1. If a module is already inserted in a module slot, the module needs to be removed before de-
provisioning the module type on the slot.
2. If a slot is already provisioned for one type of module, you cannot insert another type of module
into the same slot without de-provisioning it.
3. If a module is removed, and the system is restarted, the interfaces for the module will not be
created unless the re-insertion of the module has been done again.
4. Logical interfaces are not created during provisioning. Interfaces would be created only on actual
module insertion.
Related
Commands
● reload – reboot the Dell EMC Networking OS.
● show system (S-Series and Z-Series) – display the status of all stack members or a specific member.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
1616 VLAN Stacking