CLI Guide

Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage
Information
The queue-drop backoff-on-norxpfc polling-count command is used to remove the queue-
drop state if additional PFCs are not received for the specified number of polling intervals.
Example Use the storm-control pfc command in the configuration mode to enter the ‘storm-control-pfc'
configuration mode. The commands provisioned in this mode are applicable for all the interfaces that have
PFC storm enabled.
DellEMC(conf)#storm-control pfc
DellEMC(conf-storm-control-pfc)#queue-drop backoff-on-norxpfc polling-
count 20
storm-control pfc in queue-drop-state clear
You can clear the queue-drop state on an interface where the PFC storm has been triggered.
Syntax
storm-control pfc in queue-drop-state clear
Parameters None
Defaults None
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage
Information
The storm-control pfc in queue-drop-state clear command is used to clear the queue-
drop state on a particular interface where the PFC storm has been triggered.
Example
DellEMC(conf-if-te-1/1/1/1)# storm-control pfc in queue-drop-state clear
show storm-control pfc status
You can view the status of the PFC storm on a stack unit with specific port set.
Syntax
show storm-control pfc status stack-unit {unit-number} port-set {portpipe-number}
Parameters
unit-number Enter the stack unit number.
portpipe-number Enter the port set number.
Defaults None
Command Modes EXEC Privilege.
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS
Command Line Reference Guide.
1532 Storm Control