Release Notes
Table Of Contents
- Dell Networking C9010, C1048P, N20xx, and N30xx 9.14(2.10) Release Notes
- Document Revision History
- C9010 Hardware
- C1048P Hardware
- N20xx Hardware
- N30xx Hardware
- New in This Release
- Known Behavior
- Changes to Default Behavior and CLI Syntax
- Restrictions
- Deferred Issues
- Fixed Issues
- Known Issues
- Documentation Errata
- Installation Instructions
- Update Instructions
- Support Resources
Known C9010 9.14(2.10) Software Issues
The following caveats are open in Dell EMC Networking OS version 9.14(2.10):
None.
Documentation Errata
In Dell EMC Networking C9000 Series documentation, errors occur in the following documents. Use the information in this
section to install and configure the C9010 , C1048P, N20xx or N30xx.
None.
Installation Instructions
To install and perform the initial software configuration of the C9010 network director, C1048P, N20xx, and N30xx port
extenders, see the Dell EMC Networking C9010 Getting Started Guide, Dell EMC Networking C1048P Getting Started Guide,
Dell EMC Networking N20xx and N30xx Getting Started Guide, and Dell EMC Networking N20xx and N30xx Installation Guide.
For complete information about how to configure and monitor the C9010 network director, C1048P, N20xx, and N30xx port
extenders, see the Dell EMC Networking C9000 Series Configuration Guide.
Update Instructions
The following upgrades are available for the Dell EMC Networking operating system (OS) on a C9010 switch. If you upgrade
more than one type of software image on the C9010, do so in the following order:
1. Upgrade the OS image on C9010 RPMs, line cards, and attached port extenders (PEs).
2. Upgrade the boot flash and boot selector images on C9010 RPMs and line cards, and the boot flash image on attached PEs.
3. Upgrade the FPGA and CPLD images on C9010 RPMs and line cards.
4. Upgrade the CPLD image on attached PEs.
5. Upgrade the PoE controller on attached PEs.
NOTE:
Effective from Dell EMC Networking OS 9.11(0.0P1), you can convert N20xx or N30xx series switches to port
extenders for the C9010 network director. For more details about converting the N20xx and N30xx series switches to port
extenders, see the Dell EMC Networking OS Conversion Guide for the N20xx/N30xx Series.
Prerequisites
Before you update C9010 software:
● You must be able to access the switch through an attached console, Telnet, or SSH.
● You must have administrator privilege.
Upgrading the Operating Software Image
Upgrade the OS image on C9010 RPMs, line cards, and attached port extenders by following the procedure in this section.
NOTE: The configurations shown here are examples only and are not intended to duplicate any real system or network.
NOTE: If you installed the Open Automation (OA) package on the C9010, Dell EMC Networking strongly recommends
uninstalling the OA package before you upgrade the Dell EMC Networking OS image. Then reinstall a compatible OA
package. In this way, the system installs enhancements and uninstalls incompatible OA packages after the Dell EMC
Networking OS upgrade.
8