Release Notes

Upgrading the PoE Controller
From a console attached to the primary RPM, upgrade the PoE controller image on C1048P, N20xx and N30xx PEs attached to
the C9010.
1. Upgrade the PoE controller image on a specified PE stack unit.
upgrade poe-controller pe pe-id stack-unit unit-number
EXEC Privilege
DellEMC# upgrade poe-controller pe 0 stack-unit all
Current PoE-Controller information in the system:
=========================================================
Pe Unit Current Version New Version
---------------------------------------------------------
0/0 2.65 2.65
***********************************************************************
* Warning - Upgrading PoE Controller should only be attempted *
* when necessary. Port-Extender will be reset automatically after *
* upgrade. PoE to all ports of the unit would be suspended until *
* upgrade completes and unit gets reloaded successfully. Please do not*
* Reset/Powercyle or Reload. Proceed with caution ! *
***********************************************************************
Upgrade PoE Controller Firmware for pe 0 stack-unit 0 ? [yes/no]: yes
PoE Controller upgrade in progress. Please do NOT POWER-OFF the card.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
PE 0 Slot 0 PoE Controller FirmWare upgrade successful. Resetting the port-extender.
DellEMC#
Displaying SW Versions of C9010 and C1048P, N20xx, and N30xx
Components
To verify software upgrades on C9010 RPMs, line cards, and attached port extenders, use the show revision command.
DellEMC#show revision
DEVICE IMAGE INFORMATION :
---------------------------------------------------------------------
Type Version Target
MSS FPGA 3.10 linecard (0)
CPLD 3.2 linecard (0)
IAP 3.2 linecard (0)
Boot Flash 3.3.1.21 linecard (0)
Boot Selector 3.3.0.4 linecard (0)
MSS FPGA 3.10 linecard (1)
CPLD 3.2 linecard (1)
IAP 3.2 linecard (1)
Boot Flash 3.3.1.21 linecard (1)
Boot Selector 3.3.0.4 linecard (1)
MSS FPGA 3.12 CP (0)
CPLD 3.7 CP (0)
FPGA 2.0 CP (0)
IAP 3.2 CP (0)
Boot Flash 3.3.1.19 CP (0)
Boot Selector 3.3.0.3 CP (0)
Boot Flash 3.3.1.19 RP (0)
Boot Selector 3.3.0.3 RP (0)
20