Release Notes
Table Of Contents
- Dell Networking C9010, C1048P, N20xx, and N30xx 9.14(2.10) Release Notes
- Document Revision History
- C9010 Hardware
- C1048P Hardware
- N20xx Hardware
- N30xx Hardware
- New in This Release
- Known Behavior
- Changes to Default Behavior and CLI Syntax
- Restrictions
- Deferred Issues
- Fixed Issues
- Known Issues
- Documentation Errata
- Installation Instructions
- Update Instructions
- Support Resources
***********************************************************************
Upgrade image for all linecards [yes/no]: y
IAP upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
IAP upgrade successful for all linecards.Please power cycle the system manually to
take effect.
3. Upgrade the CPLD image on C9010 line cards. This operation takes two minutes to complete.
EXEC Privilege mode
upgrade cpld-image linecard all booted
NOTE: To upgrade the CPLD image on a specified line card, use the command:
upgrade cpld-image linecard {0-9} booted
DellEMC# upgrade cpld-image linecard all booted
Current information for the system:
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
Linecard0 CPLD 3.1 3.2
Linecard1 CPLD 3.1 3.2
Linecard2 CPLD 3.1 3.2
***********************************************************************
* Warning - Upgrading CPLD is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for all linecards [yes/no]: y
CPLD upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
CPLD upgrade successful for all linecards. Please power cycle the system manually to
take effect.
4. Power cycle the C9010 by turning off each power supply, waiting two minutes, and then turning on each power supply.
Upgrading the CPLD on C1048P, N20xx, or N30xx PEs
1. From a console attached to the primary RPM, upgrade the CPLD image on C1048P, N20xx and N30xx PEs attached to the
C9010.
EXEC Privilege mode
upgrade cpld-image pe all booted
NOTE:
To upgrade the CPLD image on a specified PE, use the command:
upgrade cpld-image pe {0-255} booted
DellEMC# upgrade cpld-image pe all booted
Current information for the system:
=========================================================================
PE Stack Unit Device Name Current Version New Version
-------------------------------------------------------------------------
0 0 CPLD 24 25
1 0 CPLD 24 25
1 1 CPLD 24 25
*********************************************************************
* Warning - Upgrading CPLD is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
*********************************************************************
Upgrade CPLD Image for all pes ? [yes/no]: yes
CPLD upgrade in progress!!! Please do NOT power off the unit!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
%PE1-C1048P:0 %DOWNLOAD-6-CPLD_UPGRADE: stack-unit 0 cpld upgrade success.
18