Release Notes
Table Of Contents
- Dell Networking C9010, C1048P, N20xx, and N30xx 9.14(2.10) Release Notes
- Document Revision History
- C9010 Hardware
- C1048P Hardware
- N20xx Hardware
- N30xx Hardware
- New in This Release
- Known Behavior
- Changes to Default Behavior and CLI Syntax
- Restrictions
- Deferred Issues
- Fixed Issues
- Known Issues
- Documentation Errata
- Installation Instructions
- Update Instructions
- Support Resources
Synchronizing data to peer RPM
!!!
Proceed with RPM hot failover [confirm yes/no]: yes
c. Wait for the RPM to reboot as the standby.
d. Upgrade the MSS FPGA image.
upgrade mss-fpga-image rpm booted
DellEMC(standby)# upgrade mss-fpga-image rpm booted
Current information for the system:
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
CP FPGA 1 3.12 3.12
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for rpm 0 [yes/no]: y
FPGA upgrade in progress!!! Please do NOT power off the unit!!!
Upgrading the MSS FPGA, MSS IAP, and CPLD on C9010 Line Cards
1. From the primary RPM, upgrade the MSS FPGA image on C9010 line cards. This operation takes 10 minutes to complete.
EXEC Privilege mode
upgrade mss-fpga-image linecard all booted
NOTE:
To upgrade the MSS FPGA image on a specified line card, use the command:
upgrade mss-fpga-image linecard {0-9} booted
DellEMC# upgrade mss-fpga-image linecard all booted
Current information for the system:
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
Linecard0 FPGA 3.10 3.10
Linecard1 FPGA 3.10 3.10
Linecard2 FPGA 3.10 3.10
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Upgrade image for all linecards [yes/no]: y
FPGA upgrade in progress!!! Please do NOT power off the unit!!!
2. Upgrade the MSS IAP image on C9010 line cards. This operation takes about 10 minutes to complete.
EXEC Privilege mode
upgrade mss-iap-image linecard all booted
NOTE:
To upgrade the MSS IAP FPGA image on a specified line card, use the command:
upgrade mss-iap-image linecard {0-9} booted
DellEMC# upgrade mss-iap-image rpm booted
Current information for the system:
========================================================================
Card Device Name Current Version New Version
------------------------------------------------------------------------
Linecard0 IAP 3.1 3.2
Linecard1 IAP 3.1 3.2
Linecard2 IAP 3.1 3.2
***********************************************************************
* Warning - Upgrading IAP is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
17