Release Notes

upgrade bootselector-image rpm booted
DellEMC(standby)# upgrade bootselector-image rpm booted
Current Boot information in the system:
=================================================================
Card BootSelector Current Version New Version
-----------------------------------------------------------------
rpm 0 (CP) Boot Selector 3.3.0.3 3.3.0.4
rpm 0 (RP) Boot Selector 3.3.0.3 3.3.0.4
***********************************************************************
* Warning - Upgrading boot selectors is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Proceed Boot Selector image for RPM 0 [yes/no]: y
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Bootselector image upgrade for RPM 0 completed successfully.
5. Reload the system.
EXEC Privilege mode
reload
DellEMC# reload
System configuration has been modified. Save? [yes/no]: y
May 18 06:22:25: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to
startup-config
in flash by default
Proceed with reload [confirm yes/no]: y
syncing disks... done
unmounting file systems...
unmounting /f10/usbflash (/dev/sd0d)...
unmounting /f10/flash (/dev/wd0e)...
unmounting /boot (/dev/wd0b)...
6. Verify that the C9010 system is upgraded with the latest boot flash and boot selector images in the CP, RP, and all line
cards.
EXEC Privilege mode
show revision
Upgrading the CPLD and FPGA Images
To upgrade CPLD and FPGA images on the C9010, you must upgrade the CPLD, FPGA, microcontroller (MSS) FPGA, and MSS
inapplication programming (IAP) images on each component. There are separate commands for each operation.
If the C9010 is running Dell EMC Networking OS 9.14(1.2) or earlier, upgrade to:
● RPM MSS FPGA version 3.12
● RPM IAP version 3.2
● RPM CPLD version 3.7
● RPM FPGA version 2.0
● Line-card MSS FPGA version 3.10
● Line-card IAP version 3.2
● Line-card CPLD version 3.2
● PE CPLD version 25
● PE PoE Controller version 2.65
If your system is loaded with a CPLD and an FPGA version that are the same or higher than these versions, do not upgrade the
CPLD or FPGA.
Your system must have the Dell EMC Networking OS 9.11(0.0P1) loaded before you can upgrade the CPLD and FPGA images.
To view the CPLD and FPGA versions packed with Dell EMC Networking OS 9.11(0.0P1), enter the show revision command
in EXEC PRIVILEGE mode.
Overview
To upgrade the CPLD and FPGA images on a C9010 and attached PEs:
14