Release Notes

Current Boot information in the system:
================================================================
Card BootFlash Current Version New Version
----------------------------------------------------------------
rpm 0 (CP) Boot Flash 3.3.1.18 3.3.1.21
rpm 0 (RP) Boot Flash 3.3.1.18 3.3.1.21
***********************************************************************
* Warning - Upgrading boot flash is inherently risky and should only *
* be attempted when necessary. A failure at this upgrade may cause *
* a board RMA. Proceed with caution ! *
***********************************************************************
Proceed Boot Flash image for all cards [yes/no]: y
!!!!!!!!
Bootflash image upgrade for RPM 0 completed successfully.
Warning: Kindly save the system configuration before reloading.
DellEMC#
3. From a console attached to the primary RPM, upgrade the boot selector (BIOS) image on the primary RPM and all line cards
installed in the C9010.
EXEC Privilege mode
upgrade bootselector-image all booted
DellEMC# upgrade bootselector-image all booted
Current Boot information in the system:
========================================================================
Card BootSelector Current Version New Version
------------------------------------------------------------------------
rpm 1 (CP) Boot Selector 3.3.0.3 3.3.0.4
rpm 1 (RP) Boot Selector 3.3.0.3 3.3.0.4
Linecard0 Boot Selector 3.3.0.3 3.3.0.4
Linecard1 Boot Selector 3.3.0.3 3.3.0.4
Linecard2 Boot Selector 3.3.0.3 3.3.0.4
Linecard10 Boot Selector 3.3.0.3 3.3.0.4
Linecard11 Boot Selector 3.3.0.3 3.3.0.4
***********************************************************************
* Warning - Upgrading boot selectors is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Proceed Boot Selector image for all cards [yes/no]: y
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Bootselector image upgrade for all cards completed successfully.
NOTE:
To upgrade the boot selector image only on C9010 line cards:
upgrade bootselector-image linecard [all | {0–11}] [booted | [[flash: | ftp: | scp: |
tftp: | usbflash:] file-url]]
Where [[flash: | ftp: | scp: | tftp:| usbflash:] file-url] specifies the file transfer method and location of the boot selector
image file used to upgrade the C9010, and is in one of the following formats:
● ftp://user-id:password@host-ip/file-path
● scp://user-id:password@host-ip/file-path
● tftp://host-ip/file-path
● flash://directory-path/filename
● usbflash://directory-path/filename
To upgrade the boot selector image on a standby RPM, see Step 2.
4. If the C9010 uses a standby RPM, upgrade the boot selector image on the standby RPM:
a. Connect the C9010 console to the console port on the standby RPM and log in.
b. Upgrade the boot selector image on the standby RPM.
EXEC Privilege mode
13