Install Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
interface
Configure the primary, secondary, and control-vlan interfaces.
Syntax
interface {primary interface secondary interface control-vlan vlan-id}
To return to the default, use the no interface {primary interface secondary interface
control-vlan vlan-id} command.
Parameters
primary interface Enter the keyword primary to configure the primary interface then one of the
following interfaces and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
secondary
interface
Enter the keyword secondary to configure the secondary interface then one of
the following interfaces and the interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the slot/port[/subport] information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port/subport information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the slot/port information.
● For a port channel interface, enter the keywords port-channel then a
number.
control-vlan
vlan-id
Enter the keyword control-vlan then the VLAN ID. The range is from 1 to
4094.
Defaults None
Command Modes CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
608 Force10 Resilient Ring Protocol (FRRP)