Install Guide

Command
History
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Example
BOOT_USER # show interfaces management ethernet
Management ethernet IP address: 10.16.133.17/24
BOOT_ADMIN #
On the S6000, the output of this command includes the MAC address and port number of the assigned
management port.
Example
BOOT_ADMIN # show int man eth
Management ethernet IP address: 10.16.132.4/16
BOOT_ADMIN #
Related
Commands
interface_management_ethernet_ip_address — Assign an IP address to the Management Ethernet
interface.
reload — Configure speed, duplex, and negotiation settings for the management interface.
show serial console baud rate
Use the show serial console to show the values of the serial console baud rate.
Syntax
show serial console baudrate
Command Modes BOOT_USER
Command
History
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Example
BOOT_USER # show serial console baudrate
Serial console baudrate = 9600
watchdog <string>
Enable the watchdog timer, when the enabled watchdog timer is set to 60 seconds.
Syntax
<string> enable | disable | status | timeout | settimeout watchdog timer
Parameters
enable
Enter the keyword enable to enable the watchdog.
disable
Enter the keyword disable to disable the watchdog.
Boot Command Line Interface 335