Install Guide

Disable VXLAN instance:
DellEMC(conf)#no vxlan-instance 1
Related
Commands
feature vxlan — Enable VXLAN configuration globally on the platform.
vxlan-instance (VAP)
To configure a VXLAN-Access Port (VAP) in to VXLAN-instance
Syntax
vxlan-instance instance ID
To unconfigure VAP, use the no vxlan-instance 1 command.
Parameters
instance ID Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the
initial release.
Defaults Disabled
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.10(0.1P10) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S4048–ON.
9.4(0.0) Introduced on the S6000.
Usage
Information
You must disable vxlan-instance before unconfiguring VAP.
Related
Commands
feature vxlan — Enable VXLAN configuration globally on the platform.
vxlan-instance static
Enable VXLAN instance configuration to be static on the platform.
Syntax
vxlan-instance instance ID [static]
To delete VXLAN instance from the system, use no vxlan-instance instance ID command.
Parameters
instance ID Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the
initial release.
static Enter the keyword static to set the VXLAN instance in static mode.
Defaults Controller mode.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
EMC Networking OS Command Line Reference Guide.
Virtual Extensible LAN (VXLAN) 1677