Install Guide

Related
Commands
● sflow enable (Global) — turn sFlow globally.
sflow extended-switch enable
Enable packing information on a switch only.
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable] command.
Parameters
enable Enter the keyword enable to enable global extended information.
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.12(1.0) Introduced on the S5048F–ON.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
Dell EMC Networking OS enhances the sflow implementation for real time traffic analysis on the E-Series
to provide extended gateway information in cases where the destination IP addresses are learned by
different routing protocols and for cases where the destination is reachable over ECMP.
Related
Commands
● show sflow — displays the sFlow configuration.
1456 sFlow