Glossary

dcb pfc-queues
Configure the number of PFC queues.
Syntax
dcb pfc-queues value
Parameters
value Enter the number of PFC queues in the range of 0 through 4. The number of ports
supported based on lossless queues configured will depend on the buffer.
Default The default number of PFC queues in the system is 2 for S4810 and 1 for S6000 platforms.
Command Modes CONFIGURATION mode
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage
Information
You can configure up to a maximum of four lossless (PFC) queues. By configuring four lossless queues,
you can configure four different priorities and assign a particular priority to each application that your
network is used to process. For example, you can assign a higher priority for time-sensitive applications
and a lower priority for other services, such as file transfers. You can configure the amount of buffer
space to be allocated for each priority and the pause or resume thresholds for the buffer. This method of
configuration enables you to effectively manage and administer the behavior of lossless queues.
Example
DellEMC(conf)# dcb pfc-queues 4
dcb {ets | pfc} enable
Enable priority flow control or enhanced transmission selection on interface.
Syntax
dcb {ets | pfc} enable
● To disable ETS on interface, use “no dcb ets enable” command.
● To disable PFC on interface, use “no dcb pfc enable” command.
Defaults Enable
Command Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048–ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.3 (0.1) Introduced on S6000, S4810, and S4820T.
Data Center Bridging (DCB) 529