Glossary

Parameters
name Enter the UDF qualifier value profile name, up to 64 characters.
Defaults None
Command Modes CONFIGURATION-UDF TCAM
Example
Dell(conf-udf-tcam)# udf-qualifier-value ipnip_val1
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
udf-id — assigns value for each configured UDF ID in the given UDF TCAM profile.
udf-tcam — creates a context for UDF TCAM.
show config — displays the current UDF-Qualifier-Value Profile configuration.
udf-tcam
Create a context for UDF TCAM.
Syntax
udf-tcam name seq number
To return to the default settings, use the no udf-tcam name seq number command.
Parameters
name Enter the UDF ACL profile name, up to 64 characters.
number Enter the keyword seq then the sequence number of the Udf-Tcam table. The
range is from 1 to 512.
Defaults None
Command Modes CONFIGURATION
Example
Dell(conf)#udf-tcam ipnip seq 1
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
deny (for Standard IP ACLs)
To drop packets with a certain IP address, configure a filter.
Syntax
deny {source | any | host {ip-address}}[count [byte]] [dscp value] [order]
[fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
Access Control Lists (ACL) 277