Quick Start Manual

22 Installing and Configuring the Operating System
6 Reboot your system.
7 Check the logs to verify that all drivers were installed correctly.
NOTE: Log information can be found at: <Primary
Drive:/>Dell_Resource_CD/logs>.
8 When the installation is complete, remove the media from the CD drive.
Verifying the Temporary Directory Paths
Verify that the paths to the Temp and Tmp directories have been set correctly.
Repeat the following steps for all nodes in the cluster.
1
Click Start and select Run.
2 In the Open field, type cmd and click OK.
3 At the command prompt, type echo %Temp% and press <Enter>.
The following path is displayed:
%SystemDrive%\Temp
where %SystemDrive% is the user's local drive.
4 At the command prompt, type echo %Tmp% and press <Enter>.
The following path is displayed:
%SystemDrive%\Temp
where %SystemDrive% is the user's local drive.
5 Repeat all steps in this section for all nodes in the cluster.