Quick Start Manual

24 Installing and Configuring the Operating System
6 Reboot your system.
7 Check the logs to verify that all drivers were installed correctly.
NOTE: Log information can be found at:
<Primary Drive:/>Dell_Resource_ CD/logs
8 When the installation is complete, remove the media from the CD drive.
Verifying the Temporary Directory Paths
Verify that the paths to the Temp and Tmp directories have been set correctly.
Repeat the following steps for all nodes in the cluster.
1
Click Start and select Run.
2 In the Open field, type cmd and click OK.
Table 3-2. Qlogic HBA driver location
Qlogic HBA Type Dell PowerEdge System
Type
Driver Location
QLA 2362, QLE
2460, QLE 2462,
QLE 2560, and QLE
2562
1950, 2950, 2970, 2900,
6850, 6950, 1950 III, 2950
III, 2900 III, R900, R905,
and R805
<Primary_Drive:/>Dell_Resource
_CD/drivers/R184315
QME 2472 (4GB) M1000e (M600, M605,
M610, M710, M805, and
M905)
<Primary_Drive:/>Dell_Resource
_CD/drivers/R184315
QME 2572 (8GB) M1000e (M600, M605,
M610, M710, M805, and
M905)
<Primary_Drive:/>Dell_Resource
_CD/drivers/R197378
QLA 2362, QLE
2460, QLE 2462,
QLE 2560, QLE
2562, QME 2472,
and QME 2572
R610, R710, and T610 <Primary_Drive:/>Dell_Resource
_CD/drivers/R212695