Owner's Manual

Configuring and Deploying Oracle Database 11g 41
Installing Patchset 11.1.0.7 for Oracle 11g Clusterware
Before You Begin
Before you install patchset 11.1.0.7 for Oracle 11g Clusterware on your
system, perform the following steps:
1
Stop nodeapps on all the nodes. Enter the following:
%SystemDrive%\%CRS_HOME%\bin> srvctl stop nodeapps
-n <node name>
where %SystemDrive% is the drive on which Oracle home is configured and
%CRS_HOME% is the home directory that you created in "Installing
Oracle Clusterware Version 11.1.0.6" on page 37.
2 Select Start → Programs → Administrator Tools → Services .
3 Locate all Oracle services and stop them on both nodes.
Installing the Patchset
NOTE: You must install the patchset software from the node where the RAC 11g R1
software was installed.
1 Start the OUI located in the patchset folder. For example:
%SystemDrive%\Oracle_patch\setup.exe
where %SystemDrive% is the drive on which you unzipped the Oracle
patchset.
2 In the Welcome window, click Next .
3 In the Specify home details window, select name as OraCR11g_home
from the drop down list and click
Next .
4 In the Specify Hardware Cluster Installation Mode window, click Next .
5 In the Product-Specific Prerequisite Checks window, click Next .
6 In the Summary window, click Install .
7 In the End of Installation window, perform all the steps listed in the
Summary window. Do not perform the step instructing you to stop the
Oracle services — you should have already completed that step before you
began installing the patchset as mentioned in "Before You Begin" on
page 41.