Owner's Manual

35
8 Execute the crssetup.exe command using the next available node names and
node numbers to add CRS information for the new nodes. For example:
crssetup.exe add -nn publicnode3,3 -pn pvtnode3,
3 –vn vipnode3,3
9
Execute the racgons utility from the bin subdirectory of the CRS home to
configure the Oracle Notification Services (ONS) port number as follows:
racgons add_config new_node_name:4948
After you have completed the procedures in this section for adding nodes at the
Oracle Clusterware layer, you have successfully extended the CRS home from
your existing CRS home to the new nodes.
Adding Nodes at the Oracle RAC Database Layer
1 From the %ORACLE_HOME% \oui\bin , run the addNode.bat script. This
starts the OUI in the add node mode and displays the OUI
Welcome page.
Click
Next on the Welcome page and the OUI displays the Specify Cluster
Nodes for Node Addition
page.
2 The Specify Cluster Nodes for Node Addition page has a table showing the
existing nodes associated with the Oracle home from which you launched the
OUI. A node selection table appears on the bottom of this page showing the
nodes that are available for addition. Select the nodes that you want to add
and click
Next .
If all of the checks succeed, then the OUI displays the
Node Addition
Summary
page.
3 Click Finish and the OUI displays the Cluster Node Addition Progress page.
4 After the OUI displays the End of Node Addition page, click Exit to end
the OUI session.
5 Execute the VIPCA utility from the bin subdirectory of the Oracle home
using the
-nodelist option with the following syntax that identifies the
complete set of nodes that are now part of your RAC database beginning
with Node1 and ending with Node
N :
vipca -nodelist Node1,Node2,Node3,...NodeN