Owner's Manual

15
10 In the Cluster Configuration Storage screen, perform the following steps
for the OCR disk:
a Locate the two 120 MB partitions that you created using the procedures
in the
Storage and Networking Guide .
b Select the first partition and click Edit .
c In the Specify Disk Configuration window, select Place OCR (Primary)
on this partition
and click OK .
d Select the second partition and click Edit .
e In the Specify Disk Configuration window, select Place OCR (Mirror)
on this partition and click OK .
11 In the Cluster Configure Storage window, perform the following steps for
the Voting disk:
a Locate the three 50 MB partitions that you created using the procedures
in the
Storage and Networking Guide .
b Select the first partition and click Edit .
c In the Specify Disk Configuration window, select Place Voting Disk
on this partition
and click OK .
d Repeat steps b and c on the remaining Voting Disk partitions.
12 Click Next .
13 Ignore the warning messages and click OK .
14 In the Summary window, click Install to start the installation procedure.
NOTE: If a failure occurs in the Configuration Assistant window, perform
the following steps and see the Troubleshooting Guide.
The Install window appears, displaying an installation progression bar.
The
Configuration Assistant window appears and the OUI runs a series
of configuration tools.
The
End of Installation window appears.
15 Click Exit to finish the OUI session.
16 In the Exit window, click Yes .