Owner's Manual

Deployment Guide 33
g When prompted, click Finish .
h Repeat step a through step g for each additional drive.
13 Restart node 1 and log in as administrator.
14 After you login to node 1, restart node 2 and login as administrator.
15 On node 2, launch the Computer Management Console and remove the drive letters from the new
partitions.
NOTE: Typically, node 2 assigns drive letters to the new partitions after you restart both nodes. If the new
partition drive letters do not appear when you perform the following steps, perform the following steps on
node 1.
a
Click Start and select Run .
b In the Run field, type the following and press <Enter>:
compmgmt.msc
The Computer Management Console window appears.
c Click Navigate and select Disk Management .
d Right-click on the first partition and select Change Drive Letter and Paths .
e Click Remove .
f When prompted, click Yes to remove the drive letter.
g Repeat step d through step f for each ASM partition.
16 Use the asmtoolg tool to stamp the new ASM partitions with an ASM header.
On node 2, open an Explorer window and navigate to the following directory:
%SystemDrive%\oracle_install_files\crs\ASM Tool
17 Double-click asmtool.exe to launch the asmtoolg tool.
18 In the asmtool screen, select Add or Change Label and click Next .
19 In the Select Disks screen, perform the following:
a Press <Ctrl> and select two partitions to stamp as DATA disks.
b In the Stamp disks screen, click Next .
c Click Finish to save your settings and exit the tool.
NOTE: If an error message appears, click OK.
20 Repeat step 17 through step 19 for each remaining disk.
21 Restart the Oracle Clusterware installation procedure.
See "Installing Oracle Clusterware Version 10.2.0.1".