Owner's Manual

Deployment Guide 41
System blue
screen
The nodes
generate a blue
screen.
The nodes cannot access the
Voting disk.
1 Ensure that the HBA connection mode
firmware settings are configured properly
for your storage configuration.
If your nodes and storage system are
configured in a direct-attached
configuration, configure the
Connection
mode as:
0 - loop only .
If your nodes and storage system are
connected to each other through a Fibre
Channel switch, configure the
Connection mode as 2 - loop preferred,
otherwise point-to-point
.
2 If the problem persists, increase the
CSS misscount to a value greater than 120.
3 Perform the following:
a Shut down node 2.
b On node 1, open a command prompt.
c Type the following, and press <Enter>:
% ORA_CLUSTERWARE_HOME%\
bin
where
%ORA_CLUSTERWARE_HOME% is
the CRS home directory that you
created in "Installing Oracle
Clusterware Version 10.2.0.1."
d At the command prompt, type the
following and press <Enter>:
crsctl set css misscount
n where n is a value
greater than 120.
4 Restart node 1 and log in as
administrator.
5 Restart node 2 and log in as
administrator.
Table 1-10. Troubleshooting (continued)
Category Problem /
Symptom
Cause Recommended Corrective Action