Owner's Manual
Deployment Guide 27
Installing Oracle 10g R2 Patchset 10.2.0.2
1
Ensure that only 10.2.0.1 Clusterware and 10.2.0.1 Database binaries are installed on your system and
the seed database is not created yet.
2
Download the Patchset 10.2.0.2 from the Oracle Metalink website at
metalink.oracle.com
.
3
Unzip the patchset to
%SystemDrive%
.
Installing Patchset 10.2.0.2 for Oracle 10g Clusterware
Before You Begin
Before you install Patchset 10.2.0.2 for Oracle 10g Clusterware on your system, perform the
following steps:
1
Stop nodeapps on all the nodes. Type the following and press <Enter>:
%SystemDrive%\%CRS_HOME%\bin> srvctl stop nodeapps -n <node name>
where
%SystemDrive%
is the drive on which Oracle home is configured and
%CRS_HOME%
is the
home directory that you created in step 4 in "Installing Oracle Clusterware Version 10.2.0.1."
2
Run the above command for each node in the cluster.
3
Stop all the Oracle services on all the nodes.
Installing the Patchset
NOTE: You must install the patchset software from the node where the RAC 10g R2 software was installed. If this
is not the node where you are running the OUI, exit and install the patchset from that node.
1
Start the OUI located in the patchset folder. For example:
%SystemDrive%\Oracle_patch\setup.exe
where
%SystemDrive%
is the drive on which you unzipped the Oracle patchset.
2
In the
Welcome
screen, click
Next
.
3
In the
Specify home details
window, select
name
as
OraCr10g_home
from the drop down list and
click
Next
.
4
In the
Specify Hardware Cluster Installation Mode
window, click
Next
.
5
In the
Summary
window, click
Install
.
6
In the
End of Installation
window, perform all the steps listed in the
Summary
window. Do not
perform the step instructing you to stop the Oracle services. You must have already done that before
you began installing the patchset as mentioned in "Before You Begin."
7
On the
End of Installation
window, click
Exit
.
8
Click
Yes
to exit from the OUI.