Owner's Manual

Installing Oracle on Enterprise Linux 15
Installing 11.1.0.7 Patch Set for Oracle 11g R1 Clusterware
NOTE: You must install the patch set software from the node where the
11gR1
Clusterware software was installed.
1 Start the Oracle Universal Installer by typing the following in the terminal
window and press <Enter>:
$> cd /u01/app/oracle/patches/Disk1/
$> ./runInstaller
The Welcome screen is displayed.
2 Click Next .
3 In the Specify Home Details screen, click Next .
4 In the Specify Hardware Cluster Installation Mode screen, click Next .
5 In the Summary screen, click Install .
The Oracle Universal Installer scans your system, displays all the patches
that are required to be installed, and installs them on your system. When the
installation completes, the
End of Installation screen is displayed.
NOTE: This procedure may take several minutes to complete.
6 Read all the instructions in the message window that is displayed.
NOTE: Do not shut down the Oracle Clusterware daemons as you already
performed this procedure in
step 1 and step 2 from the section "Upgrading
Oracle Clusterware Installation" on page 14.
7 Open a terminal window.
8 Log in as root .
9 Type the following and press <Enter>:
$>$ORA_CRS_HOME/install/root111.sh
10 Repeat step 7 through step 9 on the remaining nodes, one node at a time.
11 On the first node, return to the End of Installation screen.
12 Click Exit .
13 Click Yes to exit the Oracle Universal Installer .