Deployment Guide

Deployment Guide 57
CRS When you run
root.sh following
reinstallation,
CRS fails to start.
The OCR file and Voting
Disk have not been cleared
and contain old
information.
1 Clear the OCR and Voting Disks by typing
the following lines:
dd if=/dev/zero
of=/dev/raw/ocr.dbf bs=8192
count=12800
dd if=/dev/zero of=
/dev/raw/votingdisk bs=8192
count=2560
2 Attempt to start the service again by rebooting
the node or by running
root.sh from
/opt/oracle/product/10.1.0/crs_1/
CRS When you run
root.sh, CRS fails
to start.
The oracle user does not
have permissions on
/var/tmp (specifically
/var/tmp/.oracle).
1 Make oracle user the owner of /var/tmp/.oracle
by typing
chown oracle.oinstall
/var/tmp/.oracle
2 Attempt to start the service again by rebooting
the node or by running
root.sh from:
/opt/oracle/product/10.1.0/crs_1/
CRS When you run
root.sh, CRS fails
to start.
Other CRS
troubleshooting steps have
been attempted without
success.
1 Enable debugging by adding the following line
to
root.sh :
set -x
2 Attempt to start the service again by running
root.sh from: /opt/oracle/product/10.1.0/crs_1/
3 Check log files in the following directories
to diagnose the issue:
$ORA_CRS_HOME/crs/log
$ORA_CRS_HOME/crs/init
$ORA_CRS_HOME/css/log
$ORA_CRS_HOME/css/init
$ORA_CRS_HOME/evm/log
$ORA_CRS_HOME/evm/init
$ORA_CRS_HOME/srvm/log
4 Check /var/log/messages for any error messages
regarding CRS init scripts.
5 Capture all log files for support diagnosis.
Table 1-8. Troubleshooting (continued)
Category Problem / Symptom Cause Recommended Corrective Action