Owner's Manual

Deployment Guide 25
11 In the End of Installation window, perform the procedure as listed in the window.
NOTE: You must perform the procedures as listed in the window before proceeding to the next step.
12 After completing the required procedures in as listed in the End of Installation window, click Exit .
13 In the Exit Window, click Yes .
Configuring the Listener
This section describes the steps to configure the listener, which is required for a remote client connection to
a database.
On node 1, perform the following steps:
1 Click Start , select Run , and type:
netca
2
Click OK .
3 In the Real Application Clusters, Configuration window, select Cluster configuration and click Next .
4 In the Real Application Clusters, Active Nodes window, select Select all nodes and click Next .
5 In the Welcome window, select Listener configuration and click Next .
6 In the Listener Configuration, Listener window, select Add and click Next .
7 In the Listener Configuration, Listener Name window in the Listener name field, accept the default
setting and click
Next .
8 In the Listener Configuration, Select Protocols window, in the Selected protocols field, select TCP
and click
Next .
9 In the Listener Configuration, TCP/IP Protocol window, select Use the standard port number of
1521
and click Next .
10 In the Listener Configuration, More Listeners? window, select No and click Next .
11 In the Listener Configuration Done window, click Next .
12 In the Welcome window, click Finish .