Owner's Manual

Deployment Guide 15
4 On both nodes, add the public, private, and virtual IP addresses and host name to the
%SystemRoot%\system32\drivers\etc\hosts file.
For example, the following entries use the adapter IP and host name as shown in Table 1-6:
172.16.170.1 rac1
172.16.170.2 rac2
10.10.10.1 rac1-priv
10.10.10.2 rac2-priv
172.16.170.201 rac1-vip
172.16.170.202 rac2-vip
NOTE: Because the private network IP addresses are not accessible from the public network, registering the
IP addresses with the DNS server is not required.
5 Ensure that the cluster nodes can communicate with the public and private networks.
a On node 1, open a command prompt window.
b At the command prompt, type:
ping < public_host_name >
ping <
private_host_name >
where < public_host_name > and < private_host_name > are the host names for the public and
private network adapters in the remaining node.
If the node’s network adapters do not respond to ping commands, check your network
configuration and then repeat this step.
NOTE: VIP is configured later and cannot be pinged at this point.
6 Repeat step 1 through step 5 on the remaining nodes.
Installing the Host-Based Software needed for Dell | EMC
Follow the Dell|EMC storage documentation and CD media to install Naviagent software, which is
required for this solution.
Verifying the Storage Assignment to the Nodes
1 On the Windows desktop, right-click My Computer and select Manage .
2 In the Computer Management window, click Device Manager .
3 Expand Disk drives .
4 Under Disk drives , ensure that four SCSI disk devices appear for each LUN assigned in the storage.