Owner's Manual

Deployment Guide 9
4 At the command prompt, type echo %Tmp% and press <Enter>.
The following path appears:
%SystemDrive%\Tmp
where %SystemDrive% is the user’s local drive.
Verifying Cluster Hardware and Software Configurations
Before you begin the cluster setup, ensure that the hardware installation, public and private interfaces, and
the node software are configured correctly. The following sections provide information about Fibre Channel
cluster setup.
Setting Up Your Fibre Channel Cluster
After a Dell Professional Services representative completes the setup of your Fibre Channel cluster, verify
the hardware connections and the hardware and software configurations as described in this section.
Figure 1-1, Figure 1-2, and Table 1-4 illustrates e the required cluster connections for a storage area
network (SAN)-attached Fibre Channel cluster with two nodes.
Figure 1-1. Hardware Connections for a SAN-Attached Fibre Channel Cluster
Dell | EMC CX300, CX500, CX700, CX3-20, CX3-40,
or CX3-80 Fibre Channel storage systems
public network
PowerEdge systems
(Oracle database)
Gb Ethernet switches (private network)
Dell | EMC Fibre Channel switches
(SAN)
LAN/WAN
CAT 5e/6 (copper Gigabit NIC)
CAT 5e/6 (copper Gigabit NIC)
fiber optic cables
additional fiber optic cables