Owner's Manual

28 Deployment Guide
Installing Patchset 10.2.0.2 for Oracle 10g Clusterware
Before you Begin
1 Stop the nodeapps on all the nodes:
%SystemDrive%:\%CRS_HOME%\bin> srvctl stop nodeapps -n <node_name>
where %SystemDrive% is the user’s local drive.
2
Stop all the oracle services on all the nodes.
Patchset Installation Steps
NOTE: You must install the patchset software from the node where the Oracle RAC 10g R2 software was installed.
If this is not the node from where you are running the OUI from, exit and install the patchset from that node.
1 Start the OUI located in the patchset folder.
For example: %SystemDrive%\Oracle_patch\setup.exe
where %SystemDrive% is the user’s local drive.
2
In the Welcome window, click Next.
3 In the Specify home details window, select the name as OraCr10g_home from the drop down list and
click
Next .
4 In the Specify Hardware Cluster Installation Mode Window, click Next .
5 In the Summary window, click Install .
6 At the End of installation window, perform all the steps listed in the Summary window except step 1.
7 At the End of installation window, click Exit and then click Yes to exit from the OUI.
Installing Patchset 10.2.0.2 for Oracle 10g Database
NOTE: Complete the following steps before creating a listener and a seed database. Ensure that all the
Oracle services are running.
NOTE: You must install the patchset software from the node where the Oracle RAC 10g R2 software was installed.
If this is not the node from where you are running the OUI from, exit and install the patchset from that node.
Patchset Installation Steps
1 Start the OUI located in the patchset folder.
For example: %SystemDrive%\Oracle_patch\setup.exe
where %SystemDrive% is the user’s local drive.
2
In the Welcome window, click Next .
3 In the Specify home details window, select the name as OraDb10g_home1 from the drop down list
and click
Next .