Owner's Manual

Deployment Guide 23
Enabling the Automount Option for the Shared Disks
1 On node 1, click Start and select Run .
2 In the Run field, type cmd and click OK .
3 At the command prompt, type diskpart and press <Enter>.
4 At the DISKPART command prompt, type automount enable and press <Enter>.
The following message appears:
Automatic mounting of new volumes enabled.
5
At the DISKPART command prompt, type exit and press <Enter>.
6 Close the command prompt.
7 Repeat step 1 through step 6 on each of the remaining nodes.
8 Restart node 1, and then restart the remaining nodes in sequence.
Installing Oracle RAC 10g R2 using OCFS
This section provides information about installing the Oracle RAC 10 g R2 software. The following topics
are covered:
• Installing Oracle Clusterware Version 10.2.0.1.
• Changing the
css misscount value
• Installing Oracle Database 10
g R2 with Real Application Clusters 10.2.1
• Installing 10.2.0.2 Patchset
• Installing the latest Oracle patches
• Configuring the Listener
• Creating the Seed Database
Installing Oracle Clusterware Version 10.2.0.1
1 On node 1, insert the Oracle Clusterware 10g Release 2 for Microsoft Windows CD into the CD drive.
The
Oracle Clusterware - Autorun window displays. If the Oracle Clusterware - Autorun window does
not appear:
a Click Start and select Run .
b In the Run field, type the following and click OK :
%CD-ROM drive%:\autorun\autorun.exe
where %CD-ROM drive% is the drive letter of your CD drive.
2 In the Oracle Clusterware - Autorun window, click Install/Deinstall Products . This will start the
Oracle Universal Installer (OUI) and the
Welcome screen appears.