Owner's Manual

Deployment Guide 23
d In the Virtual IPs for Cluster Nodes window, enter an unused public virtual IP address
and subnet mask for each node displayed and click
Next .
The virtual IP address must be the same as you entered in the
/etc/hosts.equiv file,
and the subnet mask must be the same as the public mask.
e Click Finish in the summary window.
A progress window appears.
f When the configuration is complete, click OK and click Exit to exit the VIPCA.
g Run root.sh on each of the other nodes in your cluster.
Wai t f or
root.sh to finish running on each node before you run it on the next node.
13 Click OK in the Setup Privileges window.
14 Click Exit in the End of Installation window and confirm by clicking Yes .
Configuring the Listener
This section describes the steps to configure the listener, which is required for remote client
connection to a database.
On
one node only , perform the following steps:
1 Log in as root .
2 Ty p e startx to start the X Window System.
3 Open a terminal window and type:
xhost +
4
As user oracle , type netca to start the Net Configuration Assistant.
5 Select Cluster Configuration and click Next .
6 On the TOPSNodes window, click Select All Nodes and click Next .
7 On the Welcome window, select Listener Configuration and click Next .
8 On the Listener Configuration, Listener window, select Add and click Next .
9 On the Listener Configuration, Listener Name window, type LISTENER in the Listener
Name
field and click Next .
10 On the Listener Configuration, Select Protocols window, select TCP and click Next .
11 On the Listener Configuration, TCP/IP Protocol window, select Use the standard port
number of 1521
and click Next .
12 On the Listener Configuration, More Listeners? window, select No and click Next .
13 On the Listener Configuration Done window, click Next .
14 Click Finish .