Owner's Manual

Deployment Guide 47
CRS Node continually
reboots.
The node does not
have access to the
quorum disk on the
shared storage.
1 Start Linux in single user mode.
2 Ty p e :
/etc/inet.d/init.crs disable
3 Verify that the quorum disk is available and the private
interconnect is alive. If it is not available, check
hardware connections and ensure that OCFS volumes
are mounted.
4 Reboot and type /etc/inet.d/init.crs
enable
CRS Node continually
reboots.
The private
interconnect is
down.
1 Start Linux in single user mode.
2 Ty p e :
/etc/inet.d/init.crs disable
3 Verify that the node can ping over the private
interconnect to the remaining nodes in the cluster.
4 Type:
/etc/inet.d/init.crs enable
5 Reboot your system.
6 In some cases, the network has a latency of up to
30 seconds before it can ping the remaining nodes in
the cluster after reboot. If this situation occurs, add the
following line to the beginning of your
/etc/inet.d/init.crs
file and reboot your system:
/bin/sleep 30
DBCA There is no response
when you click OK
in the DBCA
Summary window.
Java Runtime
Environment timing
issue.
Click again. If there is still no response, restart DBCA.
Software
installation
You receive dd
failure error
messages while
installing the
software using Dell
Deployment CD 1.
Using copies, rather
than the original Red
Hat CDs.
Use the original Red Hat CDs included with your system.
Table 1-8. Troubleshooting (continued)
Category Problem / Symptom Cause Recommended Corrective Action