Owner's Manual

Deployment Guide 23
5 Ty p e :
<CD_mountpoint>/cluvfy/runcluvfy.sh stage -pre crsinst
-n node1,node2 -r 10gR2 -verbose
where node1 and node2 are the public host names.
If your system is
not configured correctly, troubleshoot the issues and then repeat the runcluvfy.sh
command, above.
If your system is configured correctly, the following message appears:
Pre-check for cluster services setup was successful on all the nodes.
6 Ty p e :
su - oracle
7
Type the following commands to start the Oracle Universal Installer:
unset ORACLE_HOME
<CD_mountpoint> /runInstaller
The following message appears:
Was ’rootpre.sh’ been run by root? [y/n] (n)
8
Ty p e y to proceed.
9 In the Welcome window, click Next .
10 In the Specify Home Details window, change the Oracle home path to /crs/oracle/product/10.2.0/crs
and click
Next .
11 In the Product-Specific Prerequisite Checks window, ensure that Succeeded appears in the Status
column for each system check, and then click
Next .
12 In the Specify Cluster Configuration window, add the nodes that will be managed by the
Oracle Clusterware.
a Click Add .
b Enter a name for the Public Node Name , Private Node Name , and Virtual Host Name , and then
click
OK .
c Repeat step a and step b for the remaining nodes.
d In the Cluster Name field, type a name for your cluster.
The default cluster name is
crs .
e Click Next .