Owners Manual
To enter a system setup, press <F2> immediately after a power-on or re-boot.
1.In the System BIOS or System Setup screen, select System Security and press <Enter.<
The System Security screen appears.
2.In the System Security screen, verify that Password Status is Unlocked.
3.Select System Password , enter your system password, and press <Enter> or <Tab.<
Use the following guidelines to assign the system password:
–A password can have up to 32 characters.
–The password can contain the numbers 0 through 9.
–Only lower case letters are valid, upper case letters are not allowed.
–Only the following special characters are allowed: space.(`) ,([) ,(\) ,(]) ,(;) ,(/) ,(.) ,(-) ,(,) ,(+) ,(”) ,
Re-enter the system password when prompted.
4.Type the system password that you entered earlier and click OK.
5.Select Setup Password, type your system password and press <Enter> or <Tab.<
A message prompts you to re-type the setup password.
6.Type the setup password that you entered earlier and click OK.
7.Press <Esc> and a message prompts you to save the changes.
8.Press <Y> to save the changes.
The computer reboots.
/
Password Status ) (
)
(
/
.
Password Status ) (
.
> F2 <
.
1. BIOS
> Enter.<
.
2.
.
3.
,
> Enter <
> Tab.<
4.
,
> Enter <
> Tab.<
:
/
.
/
.
5. > Esc <
.
6. > Y <
.
.
63