Owner`s manual

Error Message Description

Bad command or file name Ensure that you have spelled the

command correctly, put spaces in the

proper place, and used the correct path

name.

Bad error-correction code (ECC) on disk

read

The hard drive controller detected an

uncorrectable read error.

Controller has failed The hard drive or the associated controller

is defective.

Data error The hard drive cannot read the data. For

the Windows operating system, run the

chkdsk utility to check the file structure of

the hard drive. For any other operating

system, run the appropriate corresponding

utility.

Decreasing available memory One or more memory modules may be

faulty or improperly seated. Re-install the

memory modules and, if necessary,

replace them.

Gate A20 failure One or more memory modules may be

faulty or improperly seated. Reinstall the

memory modules and, if necessary,

replace them.

General failure The operating system is unable to carry

out the command. This message is usually

followed by specific information—for

example, Printer out of paper. Take the

appropriate action to resolve the problem.

Hard-disk drive configuration error The hard drive failed initialization.

Hard-disk drive controller failure The hard drive failed initialization.

Hard-disk drive failure The hard drive failed initialization.

Hard-disk drive read failure The hard drive failed initialization.

Invalid configuration information-please

run SETUP program

The computer configuration information

does not match the hardware

configuration.

Invalid Memory configuration, please

populate DIMM1

DIMM1 slot does not recognize a memory

module. The module should be re-seated

or installed.