Manualshelf

Users Guide

ManualsBrandsDell Manuals3000 SeriesOptiPlex 330
41424344454647484950
10. Replace the computer cover (see Replacing the Computer Cover).
11. Connect your computer and devices to electrical outlets, and then turn them on.
12. See the documentation that came with the drive for instructions on installing any software required for drive operation.
13. Check the system setup for drive configuration changes (see Entering System Setup).
Drive-Panel Inserts
1. Follow the procedures in Before You Begin.
2. Remove the drive panel by sliding the drive release latch downward to open the panel. Then, remove the drive panel from the hinges.
3. Find the drive-panel insert in front of the drive bay that you want to use.
4. Gently press the release tab of the insert to remove it from the drive panel.
1
hard-drive data
cable
2
hard-drive data connector on system board (SATA0
or SATA1)
3
power cable
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
1
drive panel
2
release tab
3
drive-panel insert