Release Notes

Table 1. Issues of Server Administrator on all supported operating systems (continued)
Issue ID Functional area Description Workaround/Resolution
corresponding alert more than once
occasionally.
161422 OMSA keysigning On generation of the certificate on
the Server Administrator UI, keysigning
algorithm preference is disabled. If an
attempt is made through the Server
Administrator CLI to configure a different
keysigning algorithm, a return code of
success is displayed but will not reconfigure.
The keysigning algorithm remains the same
as the one with which the certificate was
generated.
Not available
182493 Adapter properties
information
On the Server Administrator GUI slots page,
the adapter properties information is shown
as “Not Obtained. This is a known issue in
Server Administrator.
To get these values refer to either
the Card documentation or iDRAC
interface.
186602 Alert timestamp
When two or more alerts are intermittently
generated but with the same timestamp,
then the order in which they are listed in the
logs may not be sequential.
Not available
196519 Importing PKCS#7
certificate using OMSA CLI
There is no CLI command available to upload
PKCS#7 certificate chain using OMSA CLI.
In OMSA UI:
1. Go to Preferences > General
Settings > X.509 Certificate
page.
2. Select Import a certificate
chain and click Next.
3. Select the PKCS#7 file and click
Import.
The file will be imported
successfully, and will ask to
Activate the new certificate.
4. Restart the web server to
activate the new certificate
192275 Unable to change the
IntNic1Port1BootProto BIOS
option
Server Administrator is unable to change the
BIOS setup option, IntNic1Port1BootProto in
YX4X PowerEdge Servers with legacy BIOS
because of the BIOS limitations.
Use the RACADM utility to
change the LegacyBootProto of
the associated NIC.
200265 SSL Protocol configuration
is set to TLSv1.1
Server Administrator fails to respond, if SSL
Protocol configuration of the web server is
set to TLSv1.1. Because the TLSv1.1 option
is disabled by default from JRE 11.0.11 and
later.
Do not explicitly set SSL protocol
to TLSv1.1 after fresh installation.
While upgrading, ensure SSL
protocol is set to the default option
TLSv1.1, TLSv1.2.
Issues of Server Administrator on Microsoft Windows operating
systems
The issues are applicable to Server Administrator on Microsoft Windows operating systems.
10