Reference Guide

Table Of Contents
Event ID 2477
Description
The update of hardware Root of Trust (RoT) key is successfully completed for the controller.
Severity Informational
Cause and Action Cause: The Hardware root of trust(RoT) key is successfully updated on the controller identified in the
message.
Action: No response action is required.
Related Alert
Information
Clear Alert Number: None
Related Alert Number: 751
Local Response Agent (LRA) Number: None
SNMP Trap
Numbers
None
Event ID 2478
Description
The firmware update is successful. Host must be AC power cycled to make the firmware on the controller
identified in the message effective.
Severity Informational
Cause and Action Cause: The firmware on the controller is successfully updated. However, to make the update effective,
AC power cycle the host device.
Action: Perform a AC power-cycle operation on the host.
Related Alert
Information
Clear Alert Number: None
Related Alert Number: 753
Local Response Agent (LRA) Number: None
SNMP Trap
Numbers
None
Event ID 2479
Description
The soft Secure Boot mode is detected on the controller.
Severity Informational
Cause and Action Cause: PERC controller is in soft secure boot. This is not a factory config and will need to be replaced
with a PERC controller which has hard secureboot enabled.
Action: Replace the controller that has hard SecureBoot mode enabled, and then retry the operation. For
information about replacing a PERC, see the iDRAC User's Guide.
Related Alert
Information
Clear Alert Number: None
Related Alert Number: 753
Local Response Agent (LRA) Number: None
SNMP Trap
Numbers
None
178 Storage Management Message Reference