Install Guide
Table Of Contents
- Dell EMC OpenManage Installation Guide — Microsoft Windows Version 10.1.0.0
- Contents
- Introduction
- Preinstallation Setup
- Prerequisite Checker
- Installation Requirements
- Configuring SNMP Agents
- Secure Port Server And Security Setup
- Remote Enablement Requirements
- Installing Managed System Software On Microsoft Windows Operating Systems
- Deployment Scenarios For Server Administrator
- Installer Location
- Installing Server Administrator
- System Recovery On Failed Installation
- Upgrading Managed System Software
- Uninstalling Managed System Software
- Deployment Scenarios For Server Administrator
- Installing Managed System Software On Microsoft Windows Server and Microsoft Hyper-V Server
- Using Microsoft Active Directory
- Active Directory Schema Extensions
- Extending The Active Directory Schema
- Frequently Asked Questions
Figure 1. Typical Setup for Active Directory Objects
In addition, you can set up Active Directory objects in a single domain or in multiple domains. Setting up objects in a single
domain does not vary, whether you are setting up RAC, or Server Administrator objects. When multiple domains are involved,
however, there are some differences.
The following figure shows the set up of the Active Directory objects in a single domain. In this scenario, you have two DRAC 4
cards (RAC1 and RAC2) and three existing Active Directory users (User1, User2, and User3). You want to give User1 and User2
administrator privilege on both DRAC 4 cards and give User3 login privilege on the RAC2 card.
Figure 2. Setting Up RAC Active Directory Objects in a Single Domain
34
Using Microsoft Active Directory