Release Notes

Table 1. Issues of Server Administrator on all supported operating systems (continued)
Issue ID Functional area Description Workaround/Resolution
You can edit the BIOS attributes 18 hours
after the operating system installation.
launch Lifecycle Controller while
booting.
BITS040169 Boot/HDD/UEFI sequence In case of Boot/HDD/UEFI sequence, if they
are read-only, then toggle buttons (+ and
-) and submit button are not visible. On
the BIOS setup page, dependencies may
exist between the various attributes for
Bios settings. Setting an attribute value
may change the state of the dependent
attributes to non-editable or editable. For
example, changing the Boot Mode to UEFI
from the Boot Settings page does not allow
you to configure the Boot or Hard-Disk
Drive Sequence in the BIOS Boot Settings
page. When the page is non-editable, the
toggle buttons on the page allows toggling
the order of the boot sequence. However,
settings cannot be configured since Apply
button will not available to submit the
settings.
Not available
Not
available
Restore the previous
certificate
If a new certificate imported to Server
Administrator is not active after restarting
the web server, restore the previous
certificate.
To restore the previous certificate,
do the following:
1. Stop the web server.
2. Perform one of the following as
applicable:
● On systems running
Windows:
○ Delete the file
keystore.db at
<installed
directory>\Dell\Sy
sMgt\apache-
tomcat\conf\
○ Rename the file
keystore.db.bak at
<installed
directory>\Dell\Sy
sMgt\apache-
tomcat\conf\ to
keystore.db
● On systems running Linux:
○ ￭ Delete the
keystore.db file
at /opt/dell/
srvadmin/lib64/
openmanage/
apache- tomcat/
conf
￭ Rename the
keystore.db.bak
at /opt/dell/
srvadmin/lib64/
openmanage/
apache-tomcat/
conf to
keystore.db
3. Start the web server.
8