Release Notes

Table 6. Known issues for Storage Management Service (continued)
Issue ID Functional area Description Workaround/Resolutions
Clear Redundant Path View, provided in the Change
Controller Properties controller task, and restart the
system.
NOTE: Use this command only if you have
intentionally removed the multipath connection
while rebooting the system.
Not available VMware ESXi 6.x In the VMware ESXi 6.x environment, when you create
a virtual disk using Storage Management, you may see
an error message "The task cannot be completed. The
VD creation task is completed but the OS may not be
aware of the new VDs." However, the virtual disk is
available for all operations on rebooting the system.
Not available
Not available Patrol Read Patrol Read is not supported on SSD media. The Patrol
Read feature fails for any controller that has SSD media
on a virtual disk.
Not available
Not available Hot plug of
enclosures
Hot plug of enclosures takes time to enumerate the
enclosure and its components. During this time, there
will be a delay in the response time of tasks, such as
displaying the physical disks on the physical disk page
and in the virtual disk selection page.
Not available
Not available Connecting
enclosures in
multipath
Storage Management does not permit connecting
the first enclosure in single path and attaching the
subsequent enclosures in multipath. All enclosures must
be connected in multipath to enable the multipath view.
Not available
Not available Import foreign
configuration task
is not successful
The Import Foreign Configuration task can only import
virtual disks that have consistent data. A virtual disk
with inconsistent data cannot be imported. When
importing multiple virtual disks in a single operation,
however, the Import Foreign Configuration task may
report successful completion even when inconsistent
virtual disks are present and have not been imported
successfully.
If the "Import Foreign
Configuration" task is unable
to import an inconsistent
virtual disk, then the physical
disks that belong to the
virtual disk continue to display
a "Foreign" state after the
"Import Foreign Configuration"
task completes. In this case,
repeat the "Import Foreign
Configuration" task until one of
the following occurs:
● There are no longer any
physical disks in Foreign
state after the Import
Foreign Configuration task
completes.
● You receive an error stating
that the Import Foreign
Configuration task has
not completed successfully.
This error indicates that
there are no longer any
consistent virtual disks
available to be imported.
Therefore, all virtual disks
that are not imported are
inconsistent and you can
either perform a "Clear
Foreign Configuration" to
remove the virtual disks or
16