Reference Guide

NIC013
Message Invalid AttributeName: arg1
Arguments arg1 = attribute name
Detailed
Description
An unknown AttributeName was entered for the operation.
Recommended
Response Action
Enter the correct AttributeName available in the system. Refer to the enumeration
response for desired attribute.
Category Configuration (NIC = NIC Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
NIC014
Message Invalid AttributeValue for AttributeName arg1
Arguments arg1 = attribute name
Detailed
Description
AttributeValue may be invalid because of the following causes: 1) Length of new
AttributeValue is not within minLength and maxLength 2) Value of new
AttributeValue is not within LowerBound and UpperBound 3) Value of new
Attributevalue is not one of the possible values.
Recommended
Response Action
Refer to the documentation on valid attribute values.
Category Configuration (NIC = NIC Config)
Severity Severity 2 (Warning)
No alerts are applicable for this message
NIC015
Message AttributeValue cannot be changed to read only AttributeName arg1 .
Arguments arg1 = attribute name
Detailed
Description
A set attribute operation was attempted on a read only attribute.
Recommended
Response Action
No response action is required.
Category Configuration (NIC = NIC Config)
Severity Severity 3 (Informational)
No alerts are applicable for this message
812