Reference Guide

LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC
CMC ✔* ✔* ✔ ✔*
IOV106
Message Unable to power on PCIe adapter arg1 in arg2 arg3 .
Arguments arg1 = device name, arg2 = slot type, arg3 = slot number
Detailed
Description
The Chassis Management Controller (CMC) is unable to power on adapter. Possible
reasons for power failures are: 1) Adapter not an approved adapter. 2) Adapter not
fully inserted in the slot 3) Auxiliary power cable not connected (applicable to slot 1
- 3 only). 4) Adapter is damaged.
Recommended
Response Action
Make sure a supported PCIe device is used and that it is properly inserted in the
PCIe slot. For a list of supported devices, contact the service provider.
Category System Health (IOV = IO Virtualization)
Severity Severity 2 (Warning)
Trap/EventID 2554
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔ ✔
CMC ✔ ✔* ✔* ✔
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC
CMC ✔* ✔* ✔ ✔*
IOV107
Message PCIe adapter arg1 in slot arg2 was removed while powered on.
Arguments arg1 = device dame, arg2 = slot number
Detailed
Description
The Chassis Management Controller (CMC) has detected the removal of a PCIe
adapter card while it was powered on.
Recommended
Response Action
Power down the affected server(s) and then power on the server(s). Note: OS
reboot only will not correct this issue.
Category System Health (IOV = IO Virtualization)
Severity Severity 1 (Critical)
Trap/EventID 2553
662