Reference Guide

HWC8004
Message The SD card device sensor has failed. SD card location: arg1 , SD card device type:
arg2 , SD card state: arg3 .
Arguments arg1 = location, arg2 = type, arg3 = state
Detailed
Description
The SD card device sensor of the type identified in the message has failed. The
current status of the SD card is also displayed.
Recommended
Response Action
Reinsert the SD card or try a different SD card and retry the operation. If the issue
persists, do one of the following to resolve the error: 1) If the SD card sensor is
installed on the internal SD module, replace the module. 2) If the SD card sensor is
embedded on the system board, replace the system board. . For more information,
contact your service provider.
Category System Health (HWC = Hardware Config)
Severity Severity 1 (Critical)
OMSA Event ID 5750
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔ ✔*
CMC
HWC8005
Message The SD card device has returned to normal state. SD card location: arg1 , SD card
device type: arg2 , SD card state: arg3 .
Arguments arg1 = location, arg2 = type, arg3 = state
Detailed
Description
The SD card device has returned to a normal state. The SD card type and the
current status of the SD card is also displayed.
Recommended
Response Action
No response action is required.
Category System Health (HWC = Hardware Config)
Severity Severity 3 (Informational)
OMSA Event ID 5752
628