Reference Guide

FC014
Message Invalid AttributeValue parameter content for corresponding AttributeName arg1 .
Arguments arg1 = parameter name
Detailed
Description
The AttributeValue parameter is invalid due to one of the following: 1) The length of
new AttributeValue is not within the minimum length and maximum length range
or does not comply with the governing regular expression 2) Value of new
AttributeValue is not within the lower bound and upper bound range limits 3) The
value is not one of the possible values.
Recommended
Response Action
For valid attribute values, see the FC HBA Profile specification.
Category Configuration (FC = Fiber Channel)
Severity Severity 2 (Warning)
No alerts are applicable for this message
FC015
Message Unable to change read-only attribute arg1 .
Arguments arg1 = parameter name
Detailed
Description
A set attribute operation was not successful because the attribute is read-only.
Recommended
Response Action
No response action is required.
Category Configuration (FC = Fiber Channel)
Severity Severity 3 (Informational)
No alerts are applicable for this message
FC016
Message Unable to change the attribute value of the disabled attribute arg1 .
Arguments arg1 = parameter name
Detailed
Description
A set attribute operation was not successful because the attribute is disabled.
Recommended
Response Action
No response action is required.
Category Configuration (FC = Fiber Channel)
Severity Severity 3 (Informational)
533