Reference Guide

DIS108
Message Unable to start the AutoConfig import operation, because Lifecycle Controller is
not enabled.
Detailed
Description
The server could not be successfully configured, because Lifecycle Controller is
either not installed or not enabled.
Recommended
Response Action
Verify that the Lifecycle Controller firmware on the server being configured is
installed and enabled, then restart the iDRAC by pressing the System ID button for
15 seconds. For more information about Lifecycle Controller, see the Lifecycle
Controller Users Guide available at dell.com/support/manuals.
Category Configuration (DIS = Auto-Discovery)
Severity Severity 3 (Informational)
Trap/EventID 10635
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔ ✔ ✔ ✔ ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔* ✔
CMC
DIS109
Message Unable to start the AutoConfig file import operation, because an invalid End Host
Power State value is specified in the DHCP scope option field where the
VendorID=iDRAC.
Detailed
Description
The server could not be configured because the End Host Power State value
specified in the DHCP scope option field where the VendorID=iDRAC is incorrect.
Recommended
Response Action
In the DHCP scope option field where VendorID=iDRAC, enter a end-host-power-
state (-e <0 or 1>) where 0 = Powered Off and = Powered On, and then retry the
operation.
Category Configuration (DIS = Auto-Discovery)
Severity Severity 3 (Informational)
Trap/EventID 10635
467