Reference Guide

DIAG0621
Message Network arg1 - Driver version arg2 outdated. Version arg3 or newer required for "
arg4 "
Arguments arg1 = Number, arg2 = Hex, arg3 = Hex, arg4 = EFI Driver Name
Detailed
Description
Test only warns because UEFI Network Driver is old and has known false failures.
Recommended
Response Action
Update Network firmware.
Category System Health (DIAG = Diagnostic)
Severity Severity 2 (Warning)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔
CMC
DIAG8001
Message No BIOS support for software interrupt arg1 h, function(ah) arg2 h.
Arguments arg1 = Hex, arg2 = Hex
Detailed
Description
Recommended
Response Action
No response action is required.
Category System Health (DIAG = Diagnostic)
Severity Severity 3 (Informational)
No alerts are applicable for this message
DIAG8002
Message No BIOS support for SMI interface function(ah) arg1 h.;Sensor arg2 exceeded
thermal zone arg3 . Peak zone was arg4 .
Arguments arg1 = Hex Function, arg2 = Name, arg3 = Decimal, arg4 = Decimal
437